Skip to main content

Valve Lapping



     Gate Valve And Ball Valve Lapping Works

               Valve Maintenance works


Lapping is the process of cleaning the control valve for maintenance purposes. The lapping is done with compounds that has roughness, and used to clean valve disc and nozzle seats etc., Every seat and disc from a relief valve or block valve, in general, must be subjected to lapping.


Gate Valve Service-----


Valve Lapping is basically sanding down the surface of the Valves (which allow fuel and air to flow in, and exhaust to flow out) and the Head (Holds the Camshafts and valves) where they make contact with each other.








Lapping is process in GATE VALVE where Two mainly parts That is 

1. Gate DISC

2. Gate SEAT

On both face we making proper contact face by help rubbing process.

if any one parts more cuts face in running time than leakage will start.


Lapping (Facing) on GATE DISC----





Lapping (Facing) on DISC SEAT----





Ball Valve Servicing----



      

 




Current buffing processes used to polish spherical balls and cups can detrimentally effect the roundness. Current machines used to polish spherical balls and cups have between 10-20% failure rate. The machine and process developed at Kemet International produces a mirror polish, holds geometry and can correct these failures while maintaining roundness down to 2 microns. The whole process takes less than 9 minutes. The system can be used on most materials including ceramic, natural metals and alloyed metals.


Thank you for visit here----

Youtube video on valve lapping 

 













Comments

Anonymous said…
Gate valve having more difficult to install

Popular posts from this blog

Condensate extraction pump in thermal power plant

WHAT IS CEP (CONDENSATE EXTRACTION PUMP) -  This pump is in actual efficiency booster in a thermal power plant. As we all know that very high temperature and pressure steam expands in a steam turbine and this expanded(low pressure and low temp) steam can go waste if CEP doesn't perform it's function. CEP pump circulate the -Condensate(conversion of steam into water in condenser) again into deaerator tank which prevent plant from a huge loss of water. This water can be used for making deaerator level. Condensate Extraction Pump, as the name suggests the CEP is required to extract the condensate from the Condenser. Condenser is the equipment where all the steam gets condensed and the condensate is extracted out of the same by CEPs. so where the Condensate goes after coming out of the condenser, so it goes to the DEAERATOR by moving through a series of LP heaters, where the temperature of the extracted condensate is increased to a certain degree. In deaerator the soluble gases are...

Coal mill in thermal power plant / Grinding Roller Coal mill

Grinding Roller Coal Mill Type - ZGM-123G- II This type of Coal mill using in thermal power plant where capacity above  500 MW. In this mill having three numbers of rollers and 12 numbers of Bowl Ring segments. Coal grind in between rollers and bowl ring segment here segments rotating. Three numbers roller Bowl segment

How work FD fan

 FORCE DRAUGHT FAN- The Induced Draft (ID)  fans  and  Forced Draft  ( FD )  fans  provide control for draft and forced air zoning of fuel burned furnaces of  steam generation plant  of a  thermal power plant .  Forced Draft  ( FD )  fans  are  used  for supplying the combustion air into the furnace of a boiler. Generally in Thermal power plant Measure There is Three FANS 1. FD FANS- Force draught fan uses for Providing more Oxygen for fuel Combustion in Boiler as proper fuel  combustion increase Boiler efficiency. 2. PA FANS- Primary air fan uses for Pushing Pulverized Coal from Coal mill to Boiler Burner end. 3. ID FANS- Induce Draught fan uses for Removing Ash particles and Boiler Exhaust  flue gases pulling upto Chimney.        FORCE DRAUGHT FAN AND PRIMERY AIR FAN   FD FAN OVERHAULING WORKS VIDEO  Thanks for watching now....